ACI PXP2.3G 模拟量输出模块-产品快照
- 品牌:
- ACI
- 型号:
- PXP2.3G
- 重量:
- 0.908 kg
* 所有产品信息均源于第三方公开数据或用户上传，工业链仅整合供参考，真实价格货期请联系供应商确认.
| 供应商名称 | 电话 | 备注 |
|---|---|---|
| 北京展杰兴业科技有限公司 | 010-58765566 |
产品介绍
ACI PXP2.3G 模拟量输出模块
PXP2.3G | ACI | Analog Input to Pressure Output Interface Module
ACI
The PXP*.3 is an electric to pneumatic transducer which converts an analog electrical input signal to a proportional pneumatic output. The PXP*.3 will automatically modulate its control valve(s) to regulate the branch line pressure to the selected set point as determined by the input signal. The PXP*.3 offers four selectable input ranges of 0 to 5, 0 to 10, 0 to 15 VDC and 0-20 mA that produce a 0 to 15 psig modulating output. A 0-5 VDC feedback signal indicating the resultant branch line pressure, is also provided. This signal varies linearly with branch pressure (0 volts = 0 psig, 5 volts = 15 psig). The PXP2.3 incorporates two valves and does not use air at set point. It’s branch exhaust flow and response time are not limited by an internal restrictor and are similar to its load rate. If power fails to the PXP2.3, branch line pressure remains constant if the branch line does not leak air. FAIL SAFE: The PXP2.3FS is equipped with a N.O. branch exhaust valve which allows exhaust of branch air on power failure. A manual override (jumper selectable) which controls the output pressure is provided for setup and troubleshooting. All factory calibrated products are NIST traceable. Certificates of Compliance must be ordered with product. Datasheet Installation Instructions Photo Drawing ACI Product Page
PXP2.3G | ACI | Analog Input to Pressure Output Interface Module
更多产品:
更多品牌:
