Aim-TTi TGR6000 发动机组-产品快照

产品介绍

Aim-TTi TGR6000 发动机组

Aim-TTi TGR6000 Waveform Generator 6000MHz

Aim-TTi

Aim-TTi TGR6000 6GHz RF Signal Generator The TGR6000 is a low-cost 6GHz signal generator intended for CW (carrier wave) applications where modulation is not required. Low phase noise is matched by low leakage, low residual FM and spurii. The internal timebase has a 1ppm stability, and an external frequency reference can be used. Sophisticated sweep functions enable the frequency and/or amplitude to be swept over the full range of each in a single sweep. 0MHz to 6000MHz frequency range10Hz setability, +/-1ppm frequency stabilityLocking to external frequency standard-110dBm to +7dBm amplitude, 0.1dB stepsFast stepping sweep with dwell times down to 10msList sweep of up to 1000 points of amplitude vs frequencyUser compensation tables for specific test set-upsStorage for 12 generator set-ups and 16 sweep listsCompact half-rack 2U casing uses minimum bench spaceFull remote control through RS232, USB, LAN and GPIBSignificantly lower cost than other 6GHz generators Technical specification Frequency   Frequency Range 10MHz to 6000MHz Setting Resolution 10Hz by direct keyboard entry, or in user-set increments of 10Hz to 999•999MHz by rotary control or increment–decrement keys Phase Noise 500MHz Carrier:   3GHz Carrier:   6GHz Carrier: Residual FM Equivalent peak deviation for 300Hz to 3.4kHz B/W: 12Hz at 500MHz carrier Settling Time Reference Frequency Internal or External (via rear panel BNC) Internal Accuracy +/- 1 ppm over 15°C to 30°C; +/- 2 ppm over 5°C to 40°C Internal Stability Internal Ref. Out 10MHz from 50 Ohms, amplitude 2V pk-pk into 50 Ohms External Ref In 10MHz into 50 Ohms, amplitude 2V pk-pk to 5V pk-pk Output Level   Level Range –110dBm to +7dBm (0.1μV to 500mV into 50 Ohms) Setting Resolution 0.1dB (or 0.01μV to 1mV) by direct keyboard entry, or in user-set increments of 0.1dB to 100dB (or 0.01μV to 100mV) Accuracy Better than ± 2dBm Harmonics Sub-Harmonics 3000MHz : Non-Harmonic Spurii 10kHz offset 10 to 3000MHz, 10kHz offset 3000MHz to 6000MHz Output Connector Type N Sweep Frequency and amplitude sweep Step Sweep Step frequency and/or amplitude according to a formula over a specified number of points Dwell Time Individually programmable 0.01 to 10.000sec per step Max Points 1000 Sweep Run Continuous or single. Sweep up or down Step Spacing Linear or logarithmic Sweep Triggering Manual, Ext. signal, timed (0.1 – 999.9sec) or via remote interface Sync Signal Output Stable) available during dwell time. Programmable as high or low List Sweep As for Step Sweep except that a user defined table of frequency, amplitude and dwell time values defines the steps. The table can be created within the instrument or downloaded via the remote interfaces Max Points 1000 List Storage Up to 16 Sweep Lists can be stored permanently within the instrument Point Trigger Each point in a sweep (step or list) can be subject to a trigger event rather than a dwell time. Trigger by Manual, Ext. signal or via remote interface Trim (User Level Compensation Tables) Function A table of frequency/gain pairs allows the user to modify the generator output level with respect to frequency to calibrate an entire test set up or improve the calibration of the generator alone Max Points 100 Interfaces Full digital remote control through the RS232, USB, LAN and GPIB interfaces RS-232 9-pin D connector. Variable Baud rate 1200 and 115200 Baud USB USB 2.0 connection. Operates as a virtual COM port GPIB (IEEE-488) Conforming with IEEE488.1 and IEEE488.2 LAN (Ethernet) Standard 10/100 base-T hardware connection. ICMP and TCP/IP Protocol General   Size and Weight 2U (86.5mm) height; half-rack (213mm) width; 350mm long. 3.65 kg. (8 lb) Power 110-240VAC ±10% 50/60Hz; 100-120VAC ±10% 400Hz; 60VA max Approvals Complies with EN 61010-1 (Safety) and EN61326 (EMC) Supplied with Operating manual, driver software, power lead RF ; Maximum Frequency 6000MHz; Minimum Frequency 10 MHz; Resolution 0.1 dB; Length 350mm; Sweep Linear, Logarithmic; Display Type 20 Char x 4 Rows; Width 213.5mm; Inputs AC In, Reference In, Trig In; Data Entry Keyboard; Minimum Operating Temperature +5°C; Interface Type GPIB, LAN, RS232, USB; Dimensions 350 x 213.5 x 86.5mm; Maximum Operating Temperature +40°C; Weight 3.65kg; Plug Type Type C - European Plug, Type G - British 3-pin; Height 86.5mm; Model Number p TGR 6000;

Waveform Generators